1

Check this case if you want the video device image to display as a texture. In the opposite case, it will display as a flash interface.

2

Defines the concerned object name

3

Defines the concerned material name

4

Defines the concerned technique name

5

Defines the concerned technique pass name

6

Defines the concerned texture name

1

Check this case if you want the video device image to display in the background.

2

Slide the image on X.

3

Slide the image on Y.

4

Image width.

5

Image height.

6

Horizontally inverts the camera image.

7

Changes the motion sensor sensibility.

8

Changes the minimum interval between two detection alerts.

9

Save images in the hard disk during a detection alert.

1

Enable the event allowing the image data compression.

2

Sending interval of the image data event.

3

Set the JPEG quality in percent.

4

Defines the image opacity

5

Check this case if you want the video capture device to start in the same time as the application.

6

Check this case if you want the image to display when the application start.

Connect

Start the video capture device.

Disconnect

Stop the video capture device.

Show

Display the video image.

Hide

Hide the video image.

Data changed

Based on the setting intervals. The link parameter contains the compressed image data, it can be used with the Picture PlugIT; for example in order to restore the image.

Motion detected

Sends when a motion is detected.